
Chain
A
flexible series of joined interlocking links, usually metal, used to pull
or confine or to transmit power.
Chain
Bond
A
masonry wall that is partially held together
by use of an iron bar or chain.
Chain
Guard
The
safety covering that is used over a power-transmitting chain.
Chain
Hoist
Hoist
that uses gearing to mechanically
lift a load. The gearing is attached to a drum, which has a hook and chain
attached. After the load is hooked by the chain, the drum is turned by
the gearing, which winds the chain onto the drum, lifting the load.
Chain
of Title
Official
record, detailing ownership history of a piece of property.
Chain
Intermittent Weld
Series
of welds, alternating from one side of a joint
to the other, that run along the length of the joint.
Chain
Link, Barbed Edge
Connection
at the edge of a chain link fence, which
is twisted and cut wire.
Chain
Link Fence
Interlocking
heavy lengths of wire that are stretched between metal poles.
Chain
Link, Smooth Edge
Connection
at the edge of a chain link fence, which is made of looped wire.
Chain
Operator
Used
to operate a manual valve in a fluid system,
this close looped chain is around the teeth on the outside of the wheel
which turns the valve and is long enough to be reached by a worker several
feet below the valve. The valve is opened, closed and adjusted by someone
pulling on one side of the chain loop or the other in a pulley-like
motion.
Chain
Saw
Hand
held power made up of a chain with sharp rotating teeth around a flat metal
arm, which is used to cut wood and lumber.
Chain
Vise
Pipe
vise that has a lower jaw and a chain passing around the upper circumference
of a pipe. Servicing the same function as the upper vise jaw, it is held
in slots and can be tightened to hold the pipe.
Chain
Wrench
Pipe
wrench made of a length of chain, which is permanently attached to a handle
at one end with the other end secured at various places on the handle.
For gripping, the chain is looped around the pipe.
Chair
Bent
metal device which holds rebar elevated in the
center, rather than on the bottom of the pour, when cement is poured.
Chair
Railing
Decorative,
horizontal, molding
trim installed on a wall 32 inches from the floor.
Chalk
Soft
limestone.
Chalk
Box
Box
which hold chalk and string on a reel which, when
withdrawn, becomes coated with chalk. The string is then stretch from one
point to another and then "snapped" to make a line of chalk to mark the
distance.
Chalking
Pigment
particles released as aging and deterioration of paint occurs, forming
a fine powder on the surface.
Chalking
Paint
Paint
that oxidizes to form a surface powder,
which is then washed off, along with accumulated dirt, leaving the surface
clean.
Chalk
Line
Straight
line that is made when a chalk-covered string is snapped
against a surface.
Chamber
A
room in a house. Any enclosed space.
Chamfer
Beveled
edge or corner, especially one cut on a 45-degree angle.
Change
Concept
used in valuing real property that conditions
may be altered requiring a revised estimate of market
value; for example, deterioration
of property or capital improvements.
Change
Frequency
Adjustment
schedule of an adjustable rate
mortgage.
Change
Order
Any
modification of a construction contract, which is signed by the owner,
the architect and the contractor.
This would authorize a change in work, the amount of the contract or a
change in the contract time.
Change
in Principle
The
switching, by a real estate company, from one accounting method to another.
Channel
1.
Decorative molding with a concave
groove.
2.
Groove or flute.
3.
Metal structural shape whose cross section is letter C shaped, which is
used to support installations such as door
headers, windows, etc.
4.
A radio frequency.
Channel
Block
Also
referred to as a bond beam block, rebar
can be mortared into the channel
or groove of this concrete
masonry unit to strengthen its installation.
Channel
Cable Tray
Tray
that uses a solid, one-piece bottom with side rails to support electrical
cables where there are many run next to one
another.
Channel
Iron
Metal
structural shape whose cross section is
letter C shaped, which is used to support installations such as door
headers, windows, cable tray support
and piping support.
Chapter
Seven (7)
Type
of bankruptcy filing, a provision of the
1978 Bankruptcy Reform Act, which provides for a person's property to be
divided among creditors to satisfy unpaid
debts.
Chapter
Eleven (11)
Type
of bankruptcy filing allowing restructuring
and reorganization of existing debts which is
used most often by businesses. Creditors
must vote on a debt-paying plan and a judge must approve.
Chapter
Thirteen (13)
Type
of bankruptcy filing in which a person's
obligations are paid back within a three year period, allowing the obligated
party to pay off debts without liquidating
assets.
Character
Credit
standard judging the borrower's historical record of paying loans
and is among the other considerations of the credit worthiness of the borrower.
Charcoal
Form
of carbon, which is created when organic substances are burned without
air. Useful where steady long-term heat is desired because of its slow,
even burning ability.
Charge
1.
To add electrical energy to a storage medium.
2.
To purchase on credit.
3.
To load a mixer.
4.
To fill.
5.
To place material in a furnace.
Chase
1.
The shielded vertical shaft
that houses pipes, drains,
ducts, and flues.
2.
A trench or groove.
3.
To work decorative patterns into a metal surface.
Chase
Wall
The
wall that surrounds a space through which electrical wiring is run. The
interior space is called a chase.
Chasm
A
deep crack in the earth's surface. A wide divergence of feelings or interests.
Chassis
The
structural framework supporting the body of a vehicle, cabinet, etc.
Chat
Limestone
gravel
Chat-Sawn
Finish Limestone
Limestone
that has a coarse finish.
Chattel
Portable
property, tangible or otherwise, except real
estate.
Chattel
Mortgage
Lien
on personal property that is used as collateral
for a loan.
Chattel
Real
Interests
and property directly connected with real
estate, such as leases, fixtures,
etc.
Check
1.
A sudden stop or abrupt halt.
2.
A restraint or control.
3.
A written order to a bank to pay a stated amount of money from one's account.
4.
Separation that runs along the grains and across the annual rings in a
piece of wood.
Checking
Paint
surface defect that consists of a square pattern of small cracks.
Check
Rail
Also
called meeting rails, they are the top horizontal
sash member of the bottom window and the bottom
horizontal sash member of the top window in a double
hung window that mate together tightly when closed, permitting no air
passage between the sashes.
Check
Valve
Valve
permitting flow in a single direction.
Cheek
Either
of two sides of an object, such as a door jamb
or the jaws of a vise.
Cheek
Cut
A
chamfer cut along the wide part of a board
end, allowing the board to fit securely against another framing member
at an angle, like at the end of a hip
rafter.
Cheek
Wall
A
side of an object.
Chemical
Substance
used in or obtained by a chemical process.
Chemical
Resistance
A
material's ability to withstand change from chemical
contact.
Chime
Paint
can lip which holds the can lid fastened.
Chimney
Vent
that conducts smoke and combustion products through the roof,
away from the source of combustion, such as a furnace
or fireplace.
Chimney
Back
The
back wall or lining of a furnace, chimney
or fireplace.
Chimney
Cap
Concrete
cap surrounding the top of the chimney brick
and protects the masonry from the elements.
Chimney
Cricket
The
peaked projection that is built adjacent to a chimney
for the purpose of redirecting water away from the chimney.
Chimney
Effect
The
upward flow through a channel that is named after the way hot air rises
through a chimney.
Chimney
Flue
Inside
passage of a chimney that channels smoke and heat
to the outside.
Chimney
Pot
Short
pipe at the top of a chimney, which increases ventilation
to the fireplace to reduce smoke.
China,
Vitreous
Commonly
used in the making of bathroom fixtures,
this material is impervious to water. It
is relatively brittle and subject to cracking.
China
Clay
Fine
clay paint pigment
that is resistant to abrasion.
China
Wood Oil
Also
called Tung Oil or Japanese wood oil this drying oil is taken from the
seed kernels of the Tung tree and is used in making wood finishes.
Chink
A
narrow opening; a crack; a fissure.
Chip
Board
Board
made of wood chips, which are glued together under pressure.
Chipping
Hammer
Hammer
that is used to remove scale or paint from a
metal surface or slag from a weld.
It's steel head is pointed on one end and tapered to a horizontal
edge on the other.
Chip
Seal
Finely
crushed rock spread, in a layer, over an asphalt
oil base after which is rolled smooth.
Chisel
Flat
bar shaped tool, made of steel, which has a handle on one end and the other
end sharpened to a wedge. Chisels are made for
cutting, wood, metal, stone and masonry.
Chisel,
Cold
A
metal cutting chisel which incorporates a striking
surface and handle with the shank of the chisel.
The length of the chisel is wedge shaped for
about a third of the way, tapering down to a
hardened cutting edge. Hammers are used to
strike a cold chisel.
Chisel
Tooth Saw Blade
Used
on wood, the teeth and spaces between the teeth of the cutting blade are
made to cross cut and rip cut. Most often used
for rough carpentry such as framing,
the cuts are not very smooth.
Chisel,
Wood
Wood
cutting chisel, which can be used by hand for shaving
or hit with a mallet for heavier cutting.
Chlorinated
Polyvinyl Chloride (CPVC)
Plastic
material with a higher pressure rating and a higher thermal
operating ability at any temperature than Polyvinyl
Chloride (PVC) and is used for pipe and fittings.
|